Equine Solutions Network - Colloidal Silver Generator

How To Build A Colloidal Silver Generator For Home Use

Building A Generator Supplies you will need: Two Alligator Clips Power Generator (12-24v) Silver Rods/Bars- Eight to Ten inches of PURE SILVER (.999 fine) (No. 10-14 gauge) Quart Mason Jar (preferably 2) Distilled Water PPM Tester Coffee Filters		Figure One: AC Power generator with alligator clips attached.
Directions For Building A Unit Using A Power Generator: STEP ONE Cut the adapter end off of the power generator and strip the ends of insulation to expose about and 1 ½” of wire. (SEE FIGURE ONE) STEP TWO Attach the ends of the wire one to each of the alligator clips. (SEE FIGURE ONE) STEP THREE Bend your silver rods on one end into a hook shape and hang over your jar. (SEE FIGURE TWO) STEP FOUR Attach one alligator clip to each of the rods. Adjust the rods so that they hang into the jar straight down and DO NOT TOUCH TOGETHER. (SEE FIGURES TWO & THREE) STEP FIVE After you have adjusted the rods, plug the unit in.		Figure Two: Set up. Figure Three: Set up.
HELPFUL HINTS: Jewelers don’t usually have pure silver in stock. They can order it, but you’re going to pay premium prices. Remember: DO NOT use STERLING SILVER because it contains nickel, which is TOXIC. Don’t let the Alligator Clips touch the water or you will end up with Colloidal Chrome! Reverse the silver rods, end over end, in their clips. Exchange the rods, clip to clip. Reversing and exchanging the electrodes will help extend the useful life of the silver. Only a minute amount of silver is used each time a batch of Colloidal Silver is made. Two rods of silver make approximately 24 gallons before the rods need to be replaced.
Quick Notes About Your Colloidal Silver: After making a solution, you should FILTER YOUR WATER through a coffee filter into A DARK TINTED GLASS CONTAINER. The filtering will eliminate any Silver particles that are too large, from being ingested. The purpose of the Dark Glass is to protect the solution from UV rays, thus, keeping it from falling out of suspension for a longer period of time. Plastic containers can not be used for storage as the PLASTIC WILL PULL YOUR SILVER OUT OF SUSPENSION. I would also highly recommend buying a PPM TESTER. We have purchased ours from www.wishgranted.com. Good Luck With Your Machine!